1968 Toronado Tailights Model
Posted: Thu Jun 15, 2023 1:31 pm
Hey guys!
I just designed some taillights for my 1968 Toronado so that I could 3d print them. It is a lot cheaper and easier than trying to find some originals. If you don't have a printer, there's lots of services that allow printing if you give them the models, and the prices are pretty reasonable. I printed them in transparent red.
All the info on how to print should be at the link below. Hope it is useful to the folks here.
Link to model: https://www.thingiverse.com/thing:6080117
This is the material I used: https://www.amazon.ca/dp/B01CXAJBS6?psc=1&ref=ppx_yo2ov_dt_b_product_details
Also, I've designed a printable Emblem too, may be the same on other years, not sure!
https://www.thingiverse.com/thing:5869254
I just designed some taillights for my 1968 Toronado so that I could 3d print them. It is a lot cheaper and easier than trying to find some originals. If you don't have a printer, there's lots of services that allow printing if you give them the models, and the prices are pretty reasonable. I printed them in transparent red.
All the info on how to print should be at the link below. Hope it is useful to the folks here.
Link to model: https://www.thingiverse.com/thing:6080117
This is the material I used: https://www.amazon.ca/dp/B01CXAJBS6?psc=1&ref=ppx_yo2ov_dt_b_product_details
Also, I've designed a printable Emblem too, may be the same on other years, not sure!
https://www.thingiverse.com/thing:5869254